Changes the primary plumbing system of the bathroom can be costly, so wherever possible remodeling should be done without significant alternations in the plumbing. If a bathroom is being added to the home, consider the location of existing water lines, drain, and roof stacks so that the combined bath can be installed without the expense of running long connections to the water and sewer lines.
All plumbing systems must meet local building codes, and the system may determine where a bathroom can or cannot be located about the rest of the home. In some instances, the system may affect the type of bathroom remodeling that you can do. Plumbing contractors are familiar with the system requirements, and they can guide you during the planning stage.
The plumbing system is much the same for most types of homes. Two-story homes require longer runs of piping, drains, and vents that do one-story homes. Houses constructed on concrete slabs often require special plumbing treatment for drains and water supply. For example, a wall mounted toilet allows the drain line to pass horizontally through the wall rather than into the concrete slab flooring.
If you are adding a bathroom. It is also advisable to check the water pressure available to the plumbing system. It may be the larger pipe is required to provide adequate water pressure for the additional bathroom. Consideration should also be given to the capacity of the water heater, as other bathing facilities may necessitate quantities of hot water beyond the capacity of your present water heater. In any remodeling, keep in mind that repairs to the plumbing may be necessary from time to time, so provide adequate working space under lavatories and adjacent to the other bathroom fixtures.
If you considering a replacement of the modern bathroom fixtures, it is a good idea to consult with a plumbing contractor to determine whether or not the existing piping will work satisfactorily with the new fixtures. The age and condition of some piping are such that it, too, must be replaced when the bathroom fixtures are replaced.
It is a good idea to familiarize yourself with the water shut-off valves in case you need to use them in an emergency when the plumber cannot come immediately.
Pumping in a package
Prefabricated wall structure sections that contain complete plumbing assemblies can facilitate the addition of a bathroom. Builders of new homes use the prefabricated parts as a means of cutting cost without sacrificing quality of artistry.
The section supporting members are two by 6’s or 2 by 8’s, but otherwise, the section or panel is similar to the standard stud wall. Groups are either 8 or 4 feet high (for shipping convenience) and are standardized at 84 to 88 inches in length.
Although standardized, the panels are made in a variety of layouts, from the single-wall installation to full double bathrooms and hookups for other fixtures and appliance in other rooms.
Panels are designed to comply with National Plumbing Code and Western Official Code. However, codes vary from one community to another and if occasionally the panel design does not conform the needed changes.
Copper piping, with a longer life expectancy than the galvanized pipe, is used in these groups.
Use a wall-hung toilet does not require cutting into the floor, the drain is the base of the board. An end-outlet bathtub further simplifies the installation. Thanks for reading the article about Bathroom Plumbing, I hope this article useful for you.